SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
11
WB 162 L
7
SAFETY
7.1
Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the
assembly instructions lay down in this manual.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Workbench for woodworking. Do not exceed permissible load.
Any manipulation of the machine or its parts is a misuse, in this case
HOLZMANN-
MASCHINEN
and its sales partners cannot be made liable for ANY direct or indirect
damage.
Even when the machine is used as prescribed it is still impossible to eliminate certain residual risk
factors.
Ambient conditions
The machine may be operated:
humidity
max. 70%
Temperature
+5°С to +40°С (+41°F to +104°F)
The machine shall not be operated outdoors or in wet or damp areas, only indoor use.
Inspect the machine before starting work, if parts are damaged or loose, replace them
immediately or tighten them again.
Prohibited use
The operation of the machine outside the stated technical limits described in this manual is
forbidden.
The use of the machine not according with the required dimensions is forbidden.
Any manipulation of the machine and parts is forbidden.
The use of the machine for any purposes other than described in this user-manual is
forbidden.
• The machine is not a children's toy. It is forbidden to work/play with the workbench.
8
ASSEMBLY
8.1
Delivery content
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
8.2
Workplace requirements
The workplace has to fulfill the requirements.
The ground has to be even, in level and hard and must be suitable for maximum permissible
weight load.
The machine have to be assembled according to assembly instruction.
