ASSEMBLY
HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Seite 24
Rangierwagenheber / Service jack RWH125ALU - RWH180ALU - RWH250ALU
12.2
Lifting
WARNING:
1. Park vehicle on a flat, level, solid, surface safely away from oncoming traffic. Turn off the vehicle’s engine.
Place the vehicle’s transmission in “PARK” (if automatic) or in its lowest gear (if manual). Set the vehicle’s
emergency brake. Then, chock the wheels that are not being lifted.
2. Turn the Handle counterclockwise to lower the Jack. Once the Jack is fully lowered, turn the Handle firmly
clockwise to close it.
3. Carefully position the Saddle of the Jack (Fig. 1) under the vehicle manufacturer’s recommended lifting
point.(See vehicle manufacturer’s owner’s manual for location of frame lifting point when lifting only one wheel
and frame lifting points when lifting the entire front or rear end of the vehicle.)
4. Pump the Handle until the top of the Jack’s Saddle has nearly reached the vehicle lifting point.
Note: The Jack should be positioned at 90° to the vehicle’s lifting point to ensure the Jack’s Saddle and ve-
hicle lifting point are in alignment. If not, reposition the Jack before lifting the vehicle.
5. To lift the vehicle, pump the Handle of the Jack. Use smooth, full strokes for best results.
6. Once the vehicle is raised, slide a jack stand of appropriate capacity (not included) under the proper lifting
point referred to in the vehicle owner’s manual. Always use two jack stands, position them at the same point
on each side of the vehicle.
WARNING:
The rated capacity of jack stands is per pair, not the individual capacities combined unless specifically noted
on the product by the jack stand manufacturer. Do not exceed rated jack stand capacity. Ensure that the ve-
hicle support points are fully captured between the outer lugs of both jack stands. Use a matched pair of jack
stands per vehicle to support one end only. Use 1 pair per vehicle only. Failure to do so may result in sudden
loss of load, which may cause personal injury and/or property damage.
7. Center the vehicle’s lifting point(s) on the saddle of the jack stand(s). Set the jack stand(s) according to the
manufacturer’s instructions, making sure that they lock securely into position.
Note: Always set both Jack Stands at the same height.
8. Slowly turn the Handle counterclockwise to lower the vehicle onto the saddle(s) of the jack stand(s). Then,
turn the Handle firmly clockwise to close it
W A R N I N G
When working under the vehicle, this must always be secured with safety
stands against unintentional lowering!
12.3
Lowering
1. Carefully remove all tools, parts, etc. from under the vehicle.
2. Position the Saddle under the lifting point. Turn the Handle firmly clockwise and raise load high enough to
clear the jack stands, then carefully remove jack stands.
3. Slowly turn the Handle counterclockwise (never more than 1/2 full turn) to lower the vehicle onto the
ground.
4. Lower the Jack completely. Then, store in a safe, dry location out of reach of children.
Содержание RWH125ALU
Страница 35: ......
