HOLZMANN MASCHINEN KF 200L, Руководство пользователя

Страница: 37 / 56

TROUBLESHOOTING
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 37
Kreissäge – Fräse / circular saw – spindle shaper combination KF 200L
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
 The elimination of defects does your dealer
 Repair work may only be performed by qualified personnel!
16.2 Cleaning
N O T E
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the ma-
chine!
Therfore: When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate ( with anti-rust WD40
)
17 TROUBLESHOOTING
Disconnect the machine from the power supply prior to any checks performed at the
machine itself !
Trouble Possible cause Solution
Machine does not start  With EMERGENCY STOP switch
shut off switch
 switch or a phase is broken
 Overload protection is triggered
.
 Safety fuse is blown
 Cover plate with saw blades open
 Turn to Unlock the EMERGENCY
STOP switch to the right to
 Repair the faulty circuit or
faulty phase
 Wait until the engine cools
down
 Replace the fuse
 Cover plate close
Machine stops during
operation
 Motor protection switch has
tripped
 Wait until motor has cooled
The machine vibrates
during operation
 Underground uneven or not ad-
justed adjustable feet
 bumps by adjusting the leveling
feet to compensate
Burn marks on the
workpiece
 The blade is blunt  Replace the blade
Workpiece clamped in
advancing
 stump saw blade
 riving knife thickness does not
match the used saw blade
 Replace with sharp blade
 Riving knife thickness must be
equal to or greater than the
saw blade thickness be
Rough surface after
machining
 Workpiece to be moist  Workpiece dry or use dry
material