HOLZMANN MASCHINEN KF 200L, Руководство пользователя

Страница: 32 / 56

OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 32
Kreissäge – Fräse / circular saw – spindle shaper combination KF 200L
15 OPERATION
15.1 Notes on Operation

Set the protective cover of the circular saw blade.

Run the workpiece evenly without flare-ups and without take it back to the end of cutting to.

Set the circular saw blade so high that the ring gear is really reliably covered by the protective
cover (distance between the protective cover and the workpiece - max 5 mm.

Perform the adjustment of the saw blade height and tilt only with the machine switched off.

Work only with well- honed tools.

use the push rod at the end of cutting when the distance between the circular saw blade and
the parallel ruler is less than 120 mm.

Make sure that the machine is working without vibrations.

Cracked and deformed circular saw blades can not be repaired. You must be immediately dis-
carded as scrap and are replaced by ordinary.

For repair and maintenance of circular saw blades with soldered louvers (eg soldering new cut-
ting blades ) the construction of the circular saw blades (tooth shape, tooth width) must not be
changed . The circular saw blades with soldered louvers can be grinding up to minimum di-
mensions of the lamella of 1 mm.

After the circular saw blade must be removed from service.

Select the number of teeth of the circular saw blade such that at least 2-3 teeth working simul-
taneously). If only one tooth works , a poor work surface reveals the danger the vibration and
noise exposure increases before setback increase.
15.2 operation
Check the combined 5-operation machine before starting work:
- General technical condition of the machine
- Safety devices in place and in order
- Check-diameter of the cutter shaft for wear and replace if necessary