CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
46
KAP305JL
17.2.6
Check / change carbon brushes
Check the carbon brushes after the first 50 hours of
operation with a new machine or when new brushes are
fitted. After carrying out the first check, repeat the check
every 10 hours of operation.
If the carbon is worn down to a length of 6 mm, or if the
spring or contact wire is burnt or damaged, it is
necessary to replace both brushes. If it turns out that the
brushes can be used after removal, it is possible to
remount them.
When servicing the carbon brushes, open the two locks
counterclockwise. Then remove the carbon brushes.
Replace the carbon brushes in reverse order.
17.2.7
Exchange table insert
C A U T I O N
If the table insert (1) is damaged, there is a risk that small parts may become stucked
between the table insert and the saw blade and block the saw blade
1. Remove screws (S) from the table insert (1). If
necessary, turn the rotary table and machine head to
reach the screws.
2. remove the table insert (1).
3 Install the new table insert (1).
4 Tighten the screws (S) on the table insert (1).
17.2.8
Exchange V-Belt
-
Loosen screws (S1) of the belt cover (1)
-
Remove the belt cover (1)
-
Release belt tension:
-
To do this, loosen the 6 screws (S2). Move the motor forwards by turning the grub screw
(3), this reduces the tension and the belt can be removed from the shafts.
-
Replace the old belt with a new one.
-
Use grub screw (3) to retighten the belt, fix the motor screws and attach the belt cover
again.
Содержание KAP305JL
Страница 171: ...HOLZMANN MASCHINEN GmbH www holzmann maschinen at 171 KAP305JL ...
Страница 184: ......