HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
23
KAM 65PRO
11.3.3
Adjustment for the amount of glue
Adjusting glue amount: the adjusting knob (Fig 6) can control the amount of glue applied onto
the edge. When machine has heated up and adhesive has become liquid, feed a sample edge to
check the amount of glue applied on it. Adjust until the edge is coated evenly
Do not set adjustment knob after machine has cooled down. Part of the adjusting
components will get stuck by the glue, hence no turning on the knob is allowed.
Reset scraper support pin to default setting
：
Remove top ventilated cover, loose screw (1)
adjust scrapper support pin (2)to default setting
，
use flathead (3) screw driver to press on and
tighten up the main scraper plate (4) then tighten the screw (1) after completed above
instructions(Fig 7).
11.3.4
Edge banding mobile use
Switch on main switch
Switch on heating. Heating time for 120°C (250°F) app. 4min
Adjust temperature setting to the used glue granule. To switch Mode1/Mode2 press
together for. 3 sec. When temperature
reaches up to 120°C (250°F), operating
light will turn on, turning on the feeding
switch may accelerate heating process.
It takes app. 20 ~ 30 minutes before the
glue is completely melted.
If motor is not switching on (glue has not
fully dissolved), when digital panel showing
(Er2), increase the heating temperature
and switch on motor again when reached
up re-set temp.
Before edge banding operation, make sure
the glue is completely melted into liquid
(Using the tool and glove while opening the
glue pot to check). Place the guide plate
onto the work piece and place the pressure
roll close to the work piece without
touching it. Hold the machine tightly by both hands while handling (2) and (3). Press switch (1),
and the feed starts. Place the edge into feeding entrance until the tape touches roller (4). The
tape will be transported automatically. Till the tape has reached the pressure roll then press the
nip roll against the work piece. The movement of the pressure roll automatically moves the
machine ahead. At the end of the band make sure that the machine is led further uniformly in
height and direction until the protruding band is led out of the nip roll.(Fig.8)
