HOLZMANN MASCHINEN ED1080ADIG, Руководство пользователя

Страница: 75 / 121

MAINTENANCE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 75
ED1080ADIG
Feed gear (2)
Make sure that the oil level always reaches the mark of the sight glass. To change the oil remove
the cover on the left side of the headstock, drain the oil by removing the drain plug (D). To refill
the oil use the refill opening (F). Remount the cover. Check the oil level regularly.
First oil change (running-in oil) after 100 operating hours, then change the oil once a year or after
1000 operating hours.
Apron (3)
The oil must reach the mark in the oil sight glass. To change the oil, drain the oil by removing the
drain plug (D). To refill the oil use the refill opening (F). Check the oil level regularly.
First oil change (running-in oil) after 100 operating hours, then change the oil once a year or after
1000 operating hours.
20.1.4 Other lubrication points
Gear wheels
Lubricate the gears with a heavy, non-spinning grease. Make sure that no grease gets onto belt
pulleys or belts!
Grease nipples and lubricators
Lubricate or fill grease nipples or oilers on the guide and feed spindles, on the tailstock as well as
on the face and top slides with machine oil weekly.
20.1.5 Checking and cleaning the coolant system
N O T I C E
Coolants are toxic and must not be released into the environment! Follow
the manufacturer's instructions and contact your local authority for
information on proper disposal if necessary.
Checking the coolant system
1. Open the cover to the pump
chamber/coolant tank.
2. Check the coolant level in the tank.
The liquid should be about one centimetre
below the top edge of the tank.
3. Check the level of the metal chips in the
first chamber. When the chips have
reached 3⁄4 the height of the partition,
remove the chips.
4. Check the quality of the coolant according
to the manufacturer's instructions and
replace it as recommended.
Cleaning the coolant system
1. Empty any residual coolant still contained in the coolant nozzle into the drain container.
2. Lift the tank assembly out of its anchorage.
3. Remove all metal chips and remaining coolant and clean the tank.
4. Clean the suction strainer on the pump.
5. Reinstall the coolant tank in its original place.
6. Fill the tank with fresh coolant.
7. Properly mount the cover to the pump chamber.