HOLZMANN MASCHINEN BT 1220, Руководство пользователя

Страница: 12 / 26

www.holzmann-maschinen.at
ASSEMBLY
Machine Stand Assembly
Figure C:
When you start assembling the leg stand, assem-
ble the two stand plate (D) and the two brackets
(E) together in the way as shown in Fig. A. Screws
and nuts can be found in your hardware package.
Please do not tighten the screws entirely at first,
have them tightened firmly after you completed the
assembly.
Figure D:
Put the lid (F) on the stand and tighten all the
screws.
Assembly of Machine body to the Stand
Figure E:
Put the body on the stand, remember to have the
four holes on the lid at the proper position to con-
nect with the four threaded holes on the body. Take
out blots and washers (G) from the hardware pa-
ckage to tighten the stand to the body.
Assembly of backstop
Figure F:
Mount the backstop on the body as shown in Fig. F
and remember to tighten the screw. This backstop
can keep you safer when grinding.
Assembly of worktable
Figure G:
Loosen the set screw, insert the tablet’s rod in the
hole but remember to have the flat surface of the
shaft facing the set screw.
Tighten the set screw beware that you should have
a space of 1/16” (13mm) left in between the table
and the sanding disc.
Changing the sanding angle
Figure M:
Loosen the knob and adjust the table till it reaches
the scale you demand (varies from 0°-45°). Retigh-
ten the knob
Adjust sanding belt
Figure H: Horizontal and tension adjustment of san-
ding belt
If you find that the sanding belt is too tight, too loo-
se or even not align properly at the central, use the
allen wrench to adjust the adjust knob to the proper
tension you require.
Delivery Content
Figure B: Delivery content
A) Body
F) Lid
B) Work Table G) Bolts & Washers
C) Mitre Gauge H) hardware package
D) Stand Plate I) Allen wrench
E) Stand Bracket J) Rackstop
Changing to vertical sanding position
Figure N:
Loosen the two nuts as shown in Fig. N (as shown
in the figure you can see only one nut, another one
is down below at the bottom of the disc cover,
follow the arrow instruction). After you loosen the
nuts, you can pull up the belt in vertical position
and tighten the nuts.
Figure O:
When the belt is in vertical position, you can move
the table to the front of the belt.
First of all, loosen the screw and remove the san-
ding table with the rod. Insert the rod in to the hol-
der for vertical sanding, fix it with the set screw
and readjust the table Positon as shown in Fig.O,
take notice to leave 3mm space in between the
belt and the table.
MACHINE SETUP
ENGLISH