STARTING UP
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
21
MASCHINENNAME
STARTING UP
13.1
Preparatory work
13.1.1
Checking the scope of delivery
Check the delivery for completeness and correctness upon receipt. Immediately report any
damage or missing parts to your reatailer or the shipping company. Visible transport damage
must also be noted immediately on the delivery note in accordance with the provisions of the
warranty, otherwise the goods shall be deemed duly accepted.
13.1.2
Selecting a suitable location
Select a suitable installation location. Observe the safety requirements and the dimensions of the
machine. The chosen location must also ensure a suitable connection to the electrical grid.
13.1.3
Establishing the electrical connection
W A R N I N G
Only trained personnel! The work listed in this section may result in serious injury
or death if not performed by skilled workers (electricians). The electrical connection
may therefore only be done by specially trained persons (electricians)!!
C A U T I O N
Operation is only permitted with residual current protection device (RCD with
maximum residual current of 30 mA).
N O T I C E
Only use permissible extension cables with the wire cross-sections explained in the
following table!
Voltage
Extension
Wire size
220 – 240 V
50 Hz
< 27 m
1,5 mm
2
< 44 m
2,5 mm
2
< 70 m
4,0 mm
2
< 105 m
6,0 mm
2
1.
The electrical connection of the machine is prepared for operation at an earthed socket!
2.
The connector plug must not be manipulated!
3.
The earthing conductor is yellow-green!
4.
The power supply must be fused with 10A.
5.
Make sure that the voltage/current supplied by the power source matches the
requirements of the machine.
6.
Make sure that any extension cable is in good condition and suitable for power
transmission. An undersized cable reduces the power transmission and heats up
considerably.
7.
Replace damaged cables immediately!
Содержание ABS 2480
Страница 58: ......
