Rev. 1.10
1� of ��
��to�e� 1�� �01�
Holtek 8051 e-Link Driver for Keil μVision User Manual
8-Bit 8051 Se�ies
Operating Description
Operating Description
Note:
If the Run to main() option in the right page is checked, after the debug operation is executed,
as shown in the figure below, the program will start operating until it enters main(). If Run to main()
is not selected, the program will stop at address 0 immediately after debug.
▀
Stpe 4
Press the “Settings” on the right side of the Holtek e-Link 8051 Debugger options and the
following window will appear. Press “OK” to finish.
Note:
If the Power Out box is checked, the e-Link will supply power to the target board. If this box
is not checked, an external power supply will be required.
