Page 2
For technical questions, please call 1-888-866-5797.
Item 57056
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
table of contents
Safety ........................................................................2
Specifications ............................................................6
Setup .........................................................................6
Operation ..................................................................10
Maintenance .............................................................13
Parts List and Diagram .............................................14
Warranty ...................................................................16
WarninG SyMBOLS anD DEFinitiOnS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
iMpOrtant SaFEty inStructiOnS
read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in serious injury.
Work area
1.
Keep the work area clean and well lit.
Cluttered dark areas invite accidents.
2. The work area should have adequate
drainage to reduce the possibility of
a fall due to slippery surfaces.
3. Keep the work area free of obstructions,
grease, oil, trash, and other debris. Do not
use this product in a damp or wet location.
4.
Keep bystanders, children, and visitors
away while operating.
Distractions
can cause loss of control.
personal Safety
1.
always wear eye protection.
Wear ANSI-approved safety goggles.
2.
use safety equipment.
Wear ANSI-approved, heavy-duty, chemical
resistant work gloves during set up or use.
3.
Follow all guidelines regarding materials
being extracted, including MSDS
instructions and Epa regulations.
4.
tO prEVEnt StEaM BurnS, DO nOt
OpEn cap OF HOt Or WarM raDiatOr.
uSE carE iF EXtractinG HOt OiL.
