Page 13
For technical questions, please call 1-888-866-5797.
Item 57056
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
inspection, Maintenance, and cleaning
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn off the tool, detach the air supply, safely discharge any residual air pressure
in the tool, and release the throttle and/or turn the switch to its off position before
performing any inspection, maintenance, or cleaning procedures.
tO prEVEnt SEriOuS inJury FrOM tOOL FaiLurE:
Do not use damaged equipment. if abnormal noise, vibration,
or leaking air occurs, have the problem corrected before further use.
Follow all guidelines regarding materials being extracted,
including MSDS instructions and Epa regulations.
note:
These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the air-operated tool.
1.
BEFOrE EacH uSE,
inspect the general
condition of the Fluid Extractor. Check for:
• loose hardware or housing
• misalignment or binding of moving parts
• cracked or broken parts
• any other condition that may
affect its safe operation.
2.
Daily - air Supply Maintenance:
Every day, maintain the air supply according
to the component manufacturers' instructions.
Drain the moisture filter regularly.
Performing routine air supply maintenance
will allow the tool to operate more safely
and will also reduce wear on the tool.
3. Clean external surfaces of the tool with a
clean, dry cloth. Clean the Reservoir Tank
with compatible solvent that will not damage
it to remove accumulated debris. Dispose of
solvent properly and allow Reservoir Tank to
air dry completely. Do not allow solvent to sit
in Reservoir Tank for an extended period.
4. Store the Fluid Extractor in a safe, dry,
clean location out of reach of children.
troubleshooting
problem
possible causes
Likely Solutions
Unit does not extract fluid
1. Extracting Tube detached.
2. Extracting Tube not
positioned properly.
3. All fluid has been removed.
1. Reattach Extracting Tube.
2. Firmly insert Extracting Tube
into correct location.
3. Verify there is still fluid to be removed.
Decreased suction or
tubes leaking fluid
Holes/cracks in tubes.
Check all suction/extraction tubes for
cracks. Replace any defective tubes with
new tubes. Do not repair old tubes.
Follow all safety precautions whenever diagnosing or servicing the Fluid Extractor.
