Page 5
TYPE 6.2.0.7-RF
Programming the Essex Keypad
Note
: If the User ID, or User Code/PIN has already been assigned, you will hear one long beep when # is entered. In
this case, choose a different User ID / PIN, or see the instructions for changing or deleting codes.
DEFAULT USER CODE & MASTER CODE IS “123#’’
1
The default Master Code is
“123”
.
This can be changed to a unique code 3 - 8 digits long
2 Enter
*
3 1 2 3 #
Double Beep Fast Flash
Solid
3 Enter
1
#
Double Beep Fast Flash
Slow Flash
4 Enter new master code, followed by
#
Triple Beep Fast Flash
Solid
5 Enter
* *
Double Beep
6 EXAMPLE: old code is 123, new code is 456
*
3 1 2 3 # 1 # 4 5 6 #
* *
Set Master Code
STEP ACTION BEEP Red LED
Green LED
1 Remove power
2 Jumper the “CONFIG” pins on the rear of the keypad . V = 12
3 Apply 12 VDC power to red and black wires Quadruple Beep Flash
Solid
4 Enter
9 9
followed by
#
Double Beep Flash Solid
5 Enter
2 1 4
followed by
#
Triple Beep Flash
Solid
6 Remove power
7 Remove “CONFIG” jumper
8 Reapply power
STEP ACTION BEEP Red LED
Green LED
Set Keypad Illumination to
ON ALL OF THE TIME
