HOLMS Dustbuster, Руководство по эксплуатации

Страница: 18 / 21

Holms Dustbuster
18
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 160429.
Fitting the brush roller
1. Lift the machine and roll in the brush. Lower the
machine. See figure 13.
2. Push in the motor unit and place the motor end
slewing brackets up in the container.
3. Carefully lower down the machine to the ground.
4. Fit the motor end slewing brackets to the chassis.
5. Place the single slewing bracket in position (on the
opposite side to the motor end) and fit it in the chassis.
6. Refit the slewing bracket stops, water tank, straps and
hose to the water tank.
7. Fill the 5 lucubration points.
Replacing the side brush
Unscrew the four nuts and lower the brush. Reassemble
in the reverse order, see figure 14.
Replacing the bearing pins
The protective cap should first be pried loose when
removing the bearing pins. The bearing pins are then
driven out in the direction of the arrows, see figure 15.
This is due to the holes for the pins being rifled to prevent
the pins from rotating.
Make sure that the slewing brackets and hydraulic
hoses are not jammed when the machine is put on
the ground.
Always use Loctite on the screws.
13.Refitting the motor
Clamp plate for slewing brackets
14.Replacing the brush
15.Fitting/removing the bearing
pins