HOLMS Dustbuster, Руководство по эксплуатации

Страница: 16 / 21

Holms Dustbuster
16
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 160429.
Maintenance
After operation
• Wash the sweeper. This will increase its service life
and make it easier to detect any leakage or other
faults.
• Inspect the machine and make sure that the hoses,
rubber housings and the machine body are not
damaged. Also check for any oil leakage.
Replacing the brush
Tools
• hex key
• socket wrench
• ring spanner
• screwdriver
• rubber mallet
Carefully lower down the container to the ground.
Removing the brush roller
1. Drain the water tank by disconnecting the quick
coupling at the tank, see figure 9. Then disconnect the
straps (A figure 10) and lift the water tank out.
2. Remove the lifting stops on both the right and left
side. See C figure 10.
3. Release the front attachments on the slewing brackets
on both sides. See D figure 10.
Note that only the screws are released from the
outside, and that the slewing brackets themselves may
be left in position in their clamp plates, see figure 10.
4. Carefully lift up the machine to allow the motor to be
pulled out from the side. See figure 11.
5. Lift up the machine and remove the roller.
Make sure that the brush has stopped moving
before maintenance.
If the machine is lifted up too high before the
motor unit has been pulled out, the roller can be
left hanging from the hydraulic hoses and there is
a risk of damaging them.
9.Quick couplings
10.Removing the water tank, lifting
stops and slewing brackets
A
C
D
C
D
11.
11.Removing the motor
Clamp plate for slewing brackets