HOLMS Dustbuster, Руководство по эксплуатации

Страница: 13 / 21

Holms Dustbuster
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 160429.
13
Operating instructions
Connection to carrier
1. Connect the sweeper to the carrier by tilting the
machine attachment forwards, coupling the hook
section, lifting and tilting back. The machine must
then be locked. See Instruction Manual for the carrier
in question.
2. Connect the power hoses' quick couplings to the third
function's hydraulic terminal or to the hydraulic
motor circuit on the carrier.
3. Connect the electric cable on the water pump to the
carrier. The socket must be rated for at least 10
Ampere.
4. Start the roller brush by moving the lever for the third
hydraulic function to its locked position, or activate
the hydraulic motor circuit.
5. Check that the sweeper roller is rotating in the right
direction, see figure 3 If the roller brush rotates in the
wrong direction when in the locked position, change
the locked position for the lever or change the quick
coupling for the third hydraulic function.
Adjusting the height and tilt of the machine, sweeper with
three support wheels
1. Lift the sweeper.
2. Tilt until the sweeper is horizontal.
3. Lower the sweeper gently until the yellow markings
on the set of support wheels, see figure 4, are in line.
4. Readjust the tilt where appropriate as per item 2.
Check that the machine is secured.
It is extremely important that the hydraulic
couplings are clean. Allowing dirt into the
hydraulic system would severely impair sweeper
functionality.
Operate carefully in transport position on uneven
surfaces, to avoid exposing the sweeper to undue
strain.
3.Direction of rotation
4.
4.Yellow markings on support
wheel set
Markings