Holmatro PCT50, Руководство пользователя

Страница: 48 / 195

EN
48 916.400.139_002 PCT50
6.3.2 Tool movement
The cutting blades open and close relatively quickly until they encounter resistance. Then the pump will
build up the required pressure for spreading, cutting, pulling or squeezing.
6.3.3 Cutting
Refer to Fig. 11 and Fig. 12.
• Open the blades.
• Place the tool with opened blades perpendicular to the object to be cut.
• Place the object to be cut as deeply as possible in the cutting opening.
• Close the blades.
To enable better cutting in specific situations the spreading tips can be removed.
Refer to Fig. 8
•
Push (A) and pull (B) the pin out untill it locks.
• Remove the spreading tips from the blades (C).
6.3.4 Squeezing
• Open the blades.
• Put the blade tips over the object to be squeezed.
• Put the load 25 mm from the end of the tips. Use full width of the tips.
• Close the blades.
WARNING
Take extreme care during tool movement. Because of the enormous power of the tool parts
of the body can easily be crushed or pinched.
NOTE
When the tool is put in water it is possible that it operates in safe mode:
•
The motor operates at slow speed.
• The motor will not stop when you release the control handle or put into neutral position.
It is allowed to continue.
CAUTION
Do not cut hardened fastenings, bolts, etc. because this can damage the blades.
WARNING
Stop immediately if the blades are out of line. Danger of serious injury and of serious damage
to the equipment.
WARNING
Prevent operation of the tool when you remove or connect of accessoiries.
Avoid cutting with the blade tips only. (Fig. 13)
CAUTION
Always use the spreading tips. Make sure the lock pins stay locked.