Step 3B: For model HR3500 (2” “no
-
wobble system” version, locking hitch pin included):
Install Hitch Tube (B) into vehicle’s trailer hitch
Per Fig. 11a & 11b:
Slide the rack in the folded-up position into
the trailer hitch until it stops. Remove locking head from hitch pin
B1
and insert pin through the hole in the trailer
hitch and hitch tube until it passes through the opposite side. Tighten the front lever until good and snug. If you
intend on using the rack after assembly, then install the locking head onto the end of the hitch pin, otherwise it is
not required to complete the assembly. Front lever
position after tightening should always be pointed to the side
to avoid damage when going up or down steep driveways.
Use with 1 ¼” hitches
:
If the rack is to be used on
a 1 ¼” hitch, remove the
aluminum spacer block
from the receiver tube
with the included 4mm
Allen key
l-l
.
Fig. 17
Fig. 18
Fig. 19
B1
7
OPTIONAL LOCKING HITCH PIN AND CABLE IS
AVAILABLE FOR MODEL HR3000.
