Operation instruction
Getting started
After finishing all steps above, system is workable, follow below steps.
a) Ensure the video source output of the camera is OK, and the HD
monitor is power on and switched to connected video input port.
b) Ensure all inputs, output SDI or HDMI cables are connected.
c) Ensure all antennas are installed, and it is better to keep TX 2 anten-
nas and RX 5 antennas with orthogonal angle each other for best RF
perfor-mance. Looks like below figure.
Transmitter
Receiver
d) Ensure both the transmitter and receiver installed batteries or DC input
ports connected to outside power soutces. Then toggle power switch of trans-
mitter and receiver to ‘ON’ respectively then ‘Power’ indicator will light.
e) Ensure the frequency knobs of transmitter and receiver are set with
the same number and this will make sure the transmitter and receiver work
with same RF
f) If the camera is on and video input is OK, TX side ‘video’ indicator
will light.
11
