5
Home Screen, Select Tuning Tuning Screen, Select System System Screen, Select Ignition Setup
Figure 7 Figure 8 Figure 9
Ignition Setup, Press Ignition Type, Select HyperSpark
Figure 10
NOTE:
An ignition key cycle must be completed before the change will occur in the ECU. It is also ideal after you have
cycled the ignition, to double check that the change has been saved.
Sniper EFI Software Setup:
System Parameters > Ignition
> Select Ignition Type of “Sniper Distributor” from the drop-down menu.
Sniper EFI Software - System Parameters
Figure 11
Ignition Reference Angle
– 57.5 degrees
Inductive Delay
– This parameter is used such that ignition timing does not under or over-advance as engine speed
is increased. A starting value of 100.0 usec can be used. But once the engine is running, the engine should (safely)
be run up to 3000-4000 RPM, and timing be checked such that it matches the commanded value. If it is lower than
commanded, the Inductive Delay should be increased, if higher, the delay decreased.
OUTPUT SETUP
The following should be used if triggering a MSD Capacitive Discharge type ignition box.
Dwell Time
– 2.0 msec
