1.0 INTRODUCTION
Holley Performance Products has written this manual for the installation of the marine
PRO-JECTION 2D
fuel injection system.
This manual contains all the information needed to install this system. Please read all the
WARNINGS, NOTES,
and
TIPS,
as
they contain valuable information that can save you time and money. It is our intent to provide the best possible products for our
customer; products that perform properly and satisfy your expectations. Should you need information or parts assistance,
please contact our technical service department at 1-270-781-9741, Monday through Friday, 7 a.m. to 5 p.m. Central Time. By
using this number, you may obtain any information and/or parts assistance that you may require. Please have the part number
of the product you purchased when you call.
WARNING! The
PRO-JECTION 2D
system consists of a number of sophisticated components. Failure of any one
component does not constitute, nor does it justify, warranty of the complete system. Individual service
items are available for replacement of components. If assistance is required or if you need further
warranty clarification, you can call Holley Technical Service at the number shown above.
WARNING!
To preserve warranty, these instructions must be read and followed thoroughly and completely before
and during installation. It is important that you become familiar with the parts and the installation of the
PRO-JECTION
system before you begin. Failure to read and understand these instructions could result
in damage to
PRO-JECTION
components that are not covered by the warranty and could result in serious
personal injury and property damage.
WARNING!
For closed loop systems using an oxygen sensor, use only unleaded fuels with this product. Use of
leaded fuels will destroy the oxygen sensor and will result in incorrect exhaust gas oxygen readings and
improper fuel delivery. Failure to follow these directions does not constitute the right to a warranty
claim.
WARNING! Failure to follow all of the above will result in an improper installation, which may lead to personal injury,
including death, and/or property damage. Improper installation and/or use of this or any Holley product
will void all warranties.
2.0 WARNINGS, NOTES, AND NOTICES
WARNING!
For the safety and protection of you and others, only a trained mechanic having adequate marine fuel
system experience must perform the installation, adjustment, and repair. It is particularly important to
remember one of the very basic principles of marine safety: fuel vapors are heavier than air and tend to
collect in lower places. Any fuel spilled will vaporize and remain in the lowest extremes of the engine
compartment of your vessel where an explosive fuel/air mixture may be ignited by any spark or flame
resulting in property damage, personal injury and/or death. Extreme caution must be exercised to
prevent spillage and thus eliminate the formation of such fuel vapors. In all cases, it necessary to have
and properly operate the bilge blower for a length of time sufficient to remove all vapors before starting
your vessel’s engine.
WARNING!
United States Coast Guard (U.S.C.G.) regulations apply to vessel equipment specification and operations.
Prior to performing installation, review all pertinent U.S.C.G. rules and regulations.
WARNING!
For the safety and protection of persons and property and compliance with all U.S.C.G. and other marine
safety requirements and recommendations, the following instructions must be carefully studied and
applied.
WARNING!
Due to the large distance between the helm and the engine in most boats, it is required that the mechanic
have an assistant to operate the helm controls during removal, installation, adjustment, or repair of any
marine fuel system component, as well as during the starting procedure.
WARNING!
A U.S.C.G. approved fire extinguisher, in proper operating condition, should be nearby at all times during
removal, installation, adjustment, or repair of the marine fuel system, and during the starting procedure.
