Holiday 2014 Aluma-Lite, Руководство пользователя

Страница: 91 / 140

89
Equipment - 5
2014 Holiday Rambler Travel Trailer
4. Once the slide room has been
manually retracted, reconnect power
supply. This is necessary to stop the
slide room from moving once
retracted.
5. Take the recreational vehicle to an
authorized repair center.
Above Floor:
(Cable System)
1. Locate the slideout motor near the
ceiling of the slideout. Remove the
fascia, valance or both. The fascia
and valance may be attached by
Velcro
®
or screws.
2. Disconnect the slide room motor
electrical plug. Locate by following
the wires that run from the motor to
the plug.
3. Attach the flexible shaft to the fitting
on the end of the slideout motor.
4. Attach a ¼" socket and ratchet or
cordless drill to the other end of the
flexible shaft.
5. Turn slideout motor in proper direction
to move the slideout. Reverse
direction if cables tighten and the
motor is difficult to turn.
6. Take the recreational vehicle to an
authorized repair center
CAUTION:
Over-
torquing
can result
in severe
damage.
Maintenance
The slideout system has been designed to
require very little maintenance. To ensure
the long life of the slideout system, read and
follow these procedures.
When the room is out visually inspect
the inner slide rail assemblies. Check
for excess build-up of dirt or other
foreign material; remove any debris
that may be present.
If the system squeaks or makes any
noise it is permissible to apply a coat of
light weight oil to the drive shaft and
roller areas. Remove any excess oil to
prevent dirt and debris build-up.
Do
not use grease.
CAUTION:
Do not use petroleum based products
on the slide seal. Petroleum based
products can damage the paint and
will cause premature aging of the
rubber seal.
patio aWninG
Manual
CAUTION:
Always use the pull strap to extend
or retract the awning. Do not extend
or retract the awning by using rafter
arms. Serious injury could occur if
hands or fingers become pinched in
awning hardware.
INFORMATION:
Refer to the awning OEM manual
for more detailed information and
operating instructions.


Extending the Awning:
1. Squeeze travel lock to disengage lock
securing inner and outer rafter arms
together. Repeat for other side.
2. Place awning brake lever to Roll Down
position using awning pull rod.
3. Loosen lock knob on inner rafter. Repeat
for other side.
031166
Cable system
031262e Brake Lever
Squeeze lock to
disengage.
031262c
Inner rafter
031262f