16
Line Assembly
Step 11 – Continued
11.2
Loop the line around the groove in the
line tie-off saddle. Pull tight to prevent the
line from slipping.
12.2
Insert the line into the slot of the line tie off
saddle and through the side. Pull through
15cm+ of excess line for tensioning.
11.4
Continue feeding the line through the
holes in the arm ensuring all lines are
parallel (refer to
Fig. 20
for the
threading pattern for your product).
11.3
Feed the line through holes in the arm.
11.2
Loop the line around the groove in the
line tie-off saddle. Pull tight to prevent the
line from slipping.
11.1
Insert the PVC line into the slot of the
line tie-off saddle. Pull through
15cm+ of excess line for tensioning.
11.4
Continue feeding the line through the
holes in the arm ensuring all lines are
parallel (refer to
Fig. 20
for the
threading pattern for your product).
11.3
Feed the line through holes in the arm.
11.5
Insert the line into the slot of the last line
tie-off saddle, repeat the tie-off.
11.7
Trim off excess PVC line at dotted line
pulled back into the line tie-off saddle.
11.6
Check that all the lines are tight and
adjust and retension if necessary.
11.5
Insert the line into the slot of the last line
tie-off saddle, repeat the tie-off.
11.7
Trim off excess PVC line at dotted line
pulled back into the line tie-off saddle.
11.6
Check that all the lines are tight and
adjust and retension if necessary.
