11
Assembly
Step 7 – Adjusting the width of your Folding Clothesline
7.1 Your Folding Clothesline width can be reduced to suit your specific installation needs or to
align with existing stud centres.
The standard mount hole centres for your Folding Clothesline model are shown in the table
on page 5.
Determine the length you need to reduce your product, halve this amount and cut equal
lengths from the ends of the assembled spreader with a hacksaw. Refer Fig. 12.
For the Double Folding Clothesline model, you will need to cut both the inner and outer
assembled spreader bars.
7.2 Cutting equal amounts from each end of the spreader will maintain the spreader handle in
the centre of the product.
7.3 Be careful when cutting with a hacksaw, ensure you do not slip/damage the powdercoat and
keep the cut edge square. You may need to clean up the edges with a file after cutting.
7.4 Make sure the inside of the cut edges are smooth to allow the corners to slide in easily.
Cut equal lengths
from each end
Fig. 12
