HOLDEN GEN III V8, Обучение по обслуживанию

Страница: 33 / 113

GEN III V8 ENGINE MANAGEMENT
F1: Diagnostic Trouble Codes
The following functions will be available in this mode:
FO: Read Current DTC Information - a listing of all (if any) current DTCs that have been set by the PIM will
be displayed. A short description of what the DTC is, is also displayed in this mode.
Diagnostic Trouble Codes
There are four (4) PIM DTCs that will set. Each of these DTCs have corresponding diagnostic tables. The four
(4) DTCs that will set are:
DTC
B2002
B2006
B2007
B2009
DTC DESCRIPTION
Low Speed Fan No BCM Response
No Serial Data From PCM
Starter Relay Voltage High
EEPROM Checksum Error
There are twenty (20) other PIM DTCs that will also set whenever DTC B2006 sets. These DTCs indicate the
loss of part of the Class II serial data. If there is a problem with the Class II serial data circuit, and the PIM does
not receive any of this information a DTC B2006 will set. The Power-train On Board Diagnostic (OBD) System
Check will identify a problem with the serial data circuit or other circuits, and direct the technician in the proper
direction for diagnosis. There are no PIM DTC tables associated with these twenty (20) PIM DTCs, so always
diagnose the PCM first.
DTC
B2017
B2018
B2019
B2020
B2021
B2022
B2023
B2024
B2025
B2026
B2027
B2028
B2029
B2030
B2031
B2032
B2033
B2034
B2035
B2036
DTC DESCRIPTION
No Throttle Position Sensor (TPS) Information
No A/C Clutch Information
No Engine Speed Information
No Vehicle Speed Information
No Commanded Gear Information
No Transmission Type
No Low Speed Fan Run On Information
No Low Speed Fan Request Information
No Engine Coolant Temp (ECT) Information
No Fuel Flow Rate Information
No Fuel Used Counter Information
No A/C Pressure Information
No PRNDL Information
No Engine Oil Information
No Oil Pressure Information
No Shift Information
No Check Power-train Lamp Information
No Low Coolant Level Information
No Barometric Pressure Information
No PCM Information
F1: Clear DTC Information - simply select Clear Codes, and TECH 2 will command the PIM to clear all
DTCs. TECH 2 will then display if the DTCs have been cleared successfully or not.
Page - 28 GEN III V8 ENGINE MANAGEMENT