Hohner M 45/6, Инструкция по эксплуатации и список запасных частей

Страница: 25 / 45

Operation
Hohner Maschinenbau GmbH M 45/6 25
3.5 Straighten the stitching wire
- Fig. 10 -
The stitching wire must run absolutely straight out of the circular knife. The wire feed can be set to
run absolutely straight by turning the wire alignment roller
which is arranged on eccentric
bearings.
Wire straightening procedure:
- First remove former. (cf. 4.2.1)
a) Activate the machine's jog switch if possible.
b) Manual wire feed (cf. 3.2 Feeding the stitching wire)
Move drive of the stitching unit downwards so that the knives are open.
Wire can be fed by turning the provided adjusting handle in the clockwise direction. When
doing this, it is a good idea to cut off any overlong pieces of wire, by pressing down the knife
slider
.
(Made easier by levers on the cutting rocker )
- Turn eccentric fixing of the wire alignment roller
with the screwdriver until the stitching wire
runs absolutely straight out of the circular knife.
- Replace former (-cf. 4.2.1-).