Hofmann Geodyna 2350, Руководство по эксплуатации

Страница: 6 / 64

6
Operation manual geodyna 2350 - 9413 126
Installation of the machine
7
8
9
10
1
2
2
1
3
1
2
3
4 5
2.2 Fit (optional) wheel guard and holder
The holder for the optional wheel guard is fitted on the rear of
the wheel balancer, the wheel guard itself is fitted on the right of
the balancer.
D
Switch off the balancer.
D
Undo the two M5 hexagon head screws and remove the
rear cover plate of the wheel balancer
(Fig. 7, arrow ).
D
Fit the pre-assembled wheel guard holder (Fig. 8,
item 1) to the outside of the cabinet using the 4 hexagon
bolts M8.
D
Reach into the opening in the cabinet, pull out the lead
with plug located to the right of the opening and connect it
with the plug of the wheel guard switch.
D
Replace the plug connector into the cabinet.
D
Stick the adhesive clip (Fig. 8, item 2) on the rear of the
cabinet in a central position relative to the wheel guard
holder and insert the connecting lead of the microswitch.
D
Fit the wheel guard spring (Fig. 9, item 1) into the spring
holder (Fig. 9, item 2) .
D
Pass the holder for the wheel guard spring through the
opening, tilting it in the process, and then fit it vertically so
that the recesses in the holder are located in the cabinet
panel.
D
Extend the wheel guard spring and fit it into the bolt on
the wheel guard arbor
(Fig. 9, item 3) .
D
Slide the wheel guard (Fig. 10, item 1) on the arbor and
raise it until the fastening holes of wheel guard and wheel
guard arbor coincide.
D
Insert the M10 setscrew (Fig. 10, item 2) with washer
(Fig. 10, item 3) from below, and tighten the hexagon nut
(Fig. 10, item 4) and washer.
D
Turn on the wheel balancer at the switch.
D
Check wheel guard switch for correct setting:
When the wheel guard is open the wheel guard switch must be
pressed. The balancer must not start.
D
Place the cover (Fig. 10, item 5) onto the holder for the
wheel guard arbor and fasten by means of tapping
screws.