20
HOFFEN
8. USE
Mounting and dismounting of the kit components is only permitted
!
when the unit is switched off.
Carry out all the steps gently, careful not to damage the kit components.
!
Before and after work, check each component for signs of damage.
Damaged components must not be used, as this may cause damage to
the user’s body.
MOUNTING AND DISMOUNTING OF BRUSH TIPS
Remove the toothbrush and one of the tips from the packaging. Insert
the tip with the hole on the protruding metal spindle from the brush
holder so that the bristles of the tips point in the same direction as the
switch and diodes on the brush holder. Press the two parts together in a
decisive motion. This process is illustrated in the following figure.
To remove the tip, do the steps described and illustrated above in
reverse order.
Do not use the tip for more than 6 months after first use. Teeth or gums
!
might get injured due to excessive use of single brush or bristles
wearing off.
CHARGING THE TOOTHBRUSH BATTERY
!
Keep your hands dry before operating the charging base and
charging the battery in the device.
Before charging the toothbrush battery for the first time, discharge
it using the device. When the battery runs out of power, remove the
charging base from the packaging. Unwind the charging base cable
gently and place it on a stable horizontal surface so that the cable
reaches the power adapter.
Network adapter is not included!
Plug the USB connector of the base unit cable into a power adapter that
is normally attached to your phone/smartphone/tablet - it has a USB
output that provides power parameters such as 5 V
1A.
Insert the lower part of the toothbrush into the charging base. The power
light should start slowly flash red. This means that the battery is properly
charged.
Insert the lower part of the toothbrush into the charging base. The power
light should start slowly flash red. This means that the battery is properly
charged.
