29
7.2
Refilling the water tank
1. Make sure the device is disconnected from the power source.
2. Detach the water tank from the device main body by pulling it.
3. Turn the water tank upside down, open the silicone plug, pour
out the water if left any, and fill the tank with fresh filtered, boiled
or distilled water.
4. Close the opening with the silicone plug and put the water
tank back by aligning the recesses in the tank with the body of
the device.
CAUTION!
When the water in the tank is used up, the device will not emit steam
anymore. Refill the water tank, observing all protection measures.
If the water tank is empty, the device may overheat.
Never add any cleaning agents, fragrances, scented oils or other
chemicals to the water tank. Such agents may damage the device
and render its operation dangerous.
Only use distilled or filtered, boiled water.
Always disconnect the device from the mains before starting to fill
or empty the water tank.
The water filler plug must always be opened slowly. Thus, any steam
in the pressurised tank will be released gradually. Observe caution –
the steam may still be hot.
7.3
Switching the device on/off
1. To switch the device on, insert the power cord plug into
a properly grounded electrical outlet that matches the label or
stated in this manual or on the product packaging.
2.
The light indicator will start flashing blue.
3.
Wait for about 30 seconds until it stops flashing, which means
the device is ready to be used.
4. To enable the steam burst and start ironing, press the steam
burst switch.
5. To disable the steam burst, press the steam burst switch again.
CAUTION!
It will not fully turn off the device. It will remain in standby
mode.
Содержание GS-2097
Страница 1: ...GARMENT STEAMER PAROWNICA DO UBRAŃ INSTRUKCJA OBSŁUGI INSTRUCTION MANUAL ...
Страница 2: ......
Страница 38: ... sprytniezhoffen hoffen com pl ...