For the Advanced Setup, the Basic Setup must have been performed at least once!
1. Make sure that the ESC is off; switch on the transmitter with the throttle stick at full power.
2. Hold the Model, Connect the ESC with motor and battery => a monotonous continuous beep
should be heard.
3.
♪♪♪♪♪♪♪♪
....: after approximately 20 tones, the advanced setup is activated as long as the
basic setup has been performed!
Acknowledgement
=> Advanced Setup
If the continuous beeps are not heard, please disconnect immediately the battery from
the ESC and
try again
. Place the transmitter
within range of the
receiver if the antenna is
not extended.
In the advanced setup only ONE Menu option can be selected
at a time
, therefore the
main menu choice must take place first:
Place the stick again into full back position to select the main me
nu
to modify:
Main Menu Options overview:
♪
Brake
♪♪
Battery-Typ
e
♪ ♪
♪
Timing
♪ ♪
♪
♪
PWM-Frequency
♪ ♪ ♪
♪
♪
Governor mode
Move the stick to full power after hearing the sounds for the desired parameter.
Acknowledgement:
♪
♪
Note:
If any parameter has not be selected, the menu will begin again with “Brake” and so on
(i
f selected
)
, depending upon the selection now the ESC switches to the setting of the
Parameter. Possible (sub) menus:
1 Brake (
♪
)
Brake selection
(Brake):
Move stick into full back position again
♪
No Brake
♪♪
Brake, Brake is activated if stick range has been configured accordingly.
Move the stick to full power to select the desired setting in the submenu. Acknowledgement:
♪
♪
After the acknowledgement the menu option is programmed!