Hobbies & Helis Octane Dominator 20, Инструкция по эксплуатации

Страница: 91 / 105

Page 91 of 105
First,
set your radio so
that all travel values are at 100%. If you have a radio with Swash Mixing set, set those values to 50%
(Aileron, Elevator, and Pitch.) Then use servo reversing so that all servos are moving in the right
direction. If Pitch operates reversed, change the value in the Swash Mixing from + to -.
Step 1: First set your radio up so that all servos are moving in the right direction and adjust
all travel values to 100%. If you have a radio with Swash mixing values set those to 50% (Pitch,
Aileron and Elevator).
Now center both radio sticks (including “throttle”) and center all trim and sub-trim values.
When this is done turn your receiver pack on. Now mount the servo arms at a 90
P
o
P
angle towards the
linkage rod. In our non push pull helis this will be horizontal. Use the mounting position on the servo
arm that will be closest to 90
P
o
P
, not all servos will line up 100% correct. If they are visible off from the
90
P
o
P
position the use the sub-trim function in your radio for fine tuning, do not use regular trim for this,
see picture 1.
Now you have a good start and the rest of the setup will become easier.
Step 2: Connecting the Swashplate at the right distance. This is done by moving your
Pitch (throttle) stick all the way down, see picture 2. When the servos are in this position adjust the
length of the linkage rods so the Swashplate is located towards the bottom, but still leaves enough
room for left/right (aileron) and front/back (elevator) travel. During such travel, portions of the
Swashplate will move below the Swashplate position archived during Pitch full down radio stick
position. So make sure you leave enough room for this extra travel, see picture 2 for recommended
height. Also make sure that all 3 linkage rods between the servo arms and the Swashplate are the
same, so the Swashplate is level. It should not tilt in any direction; unless your right radio stick is
moved. If it lilts, and all linkage rods are the same length, then go back to step one and make sure
your three servo arms have the same neutral position (horizontal on non push pull helis).
Step 3: Connecting the Washout assembly. Connect the fixed length plastic “A” arms to
the Swashplate, connect to the two longer pivot studs, if all four are the same length then any two
will do. The next step is to adjust the length of the linkage rod between the Washout Arm and the
Flybar connection point. Turn your radio and receiver back on and center both sticks. Now adjust
the length of the flybar linkage so the washout arms are level (horizontal), see picture 1. Also make
sure your flybar arms and flybar-paddles are level (horizontal), when adjusting the linkage. After the
length is adjusted make sure that you have free travel in all directions and stick positions. When the
Pitch stick is all the way up it should look like picture 3. As you can see there is still plenty of room for
aileron and elevator travel. Now adjust the Washout Anti-rotation pin height so the pin is still in the
guide slot of the washout base during all travel positions. For the Left/Right Washout Anti-rotation
position, line the attachment point of the plastic washout “A” arm on the Swashplate up with flybar
linkage connection point. The imaginary line between these points should be vertical.
Now you are almost done, only one set of links left, and the length of those links will be
depending on your desired setup whether it's Aerobatic or normal flying. Please refer to the Pith
travel setup table for this final link length.