Hobbies & Helis Octane Dominator 20, Инструкция по эксплуатации

Страница: 34 / 105

Page 34 of 105
1-5 TAIL TRANSMISSION ASSEMBLY
No. Bag Description Qty
1 1 Counter Gear 1
2 1 Counter Gear Shaft 1
3 1 Counter Gear Lock Pin 1
4 1 M4 E-clip 1
5 1 Counter Gear Bearing 2
6 1 Pulley Gear 1
7 HB M3x3 Set Screw 1
8 ***** JP Weld glue 1
The Bearing Blocks shown may look differently
-Install Counter Gear to Counter
Gear Shaft using Counter Gear Lock Pin (No.
3) and M4 E-clip to secure it. Apply JP Weld
around the Pin.
-Put Counter Gear Bearing Block
(the lower) in with the Flange facing down
-Install Counter Gear Bearing Block
(the upper) with the Flange facing up
-Install Pulley Gear (No. 6)
Counter Gear Shaft is designed to fit tightly in bearings on the Bearing Blocks. So
before you do the following assembly, check to see if the shaft can go in the bearings or not.
If not, use sand paper to sand it down a little, it will come right in.
Note: Counter Gear Bearing Blocks may look differently. Ensure that the Counter Gear Lock Pin is
seated all the way down in the slot in the Counter Gear. If it is not seated it will not allow the Bearing Block to go
to the proper position and will bind on the Pulley or Gear.
QT356
QD353A &
BRG05196R
(2)
QPM04CLIP
(2)
QD551C
(1) 1
st
slide the counter gear
above the hole for the pin
then insert the pin and press
the gear down on the pin.
Observe bottom BEARING block
Lip is down which keeps bearing
from falling out.
After gear is
firmly pressed
down insert this
clip in the slot.
(2) slide this bearing onto
shaft with the lip up to hold
bearing from sliding up then
insert pin and slide pulley
down onto pin again pressing
firmly and evenly. Follow up
with second E-Clip.