1. Feel along the front edge of the blue stripe until you find the two
slots under the covering, trim out the covering over the slots.
4. Temporarily install the strut and mark the bottom of the fuselage
for the installation of the control rod Mark the hole about 1"
from the firewall and 7/8 from the left bide of the fuselage.
2. Install the two main gear struts into the wing and attach using
the plastic retaining straps and 3 x 10mm self-tapping screws.
You may with to drill eight 1/16" holes to prevent the wood from
splitting when installing the screws.
5. Drill a 1/8" hole angling back at the mark.
Attach the bellcrank onto the front gear strut and secure with a
3 x 8mm screw onto the flat.
6. Epoxy in the white tube so that it only protrudes 1/8" out of the
fuselage Make sure all exposed wood around the tube is covered
with glue in order to seal against fuel.
8.
