Hobbico Sky Zap Скачать руководство пользователя страница 2

Your SKY ZAP

plane is not a toy, but rather a

sophisticated, working model that functions very much
like an actual airplane. Because of its realistic
performance, the model, if not assembled and operated
correctly, could possibly cause injury to yourself and
spectators or damage property. 

We highly recommend that you get experienced,
knowledgeable help with assembly and during your
first flights, to make your R/C modeling experience
totally enjoyable. 
You’ll learn faster and avoid risking
your model before you’re truly ready to solo. Your local
hobby shop has information about flying clubs in your
area whose membership includes qualified instructors.
You can also contact the national Academy of Model
Aeronautics 
(AMA), which has more than 2,500
chartered clubs across the country. Instructor training
programs and insured newcomer training are available
through any one of these clubs.

Contact the AMA at the address or toll-free phone
number below.

Academy of Model Aeronautics

5151 East Memorial Drive

Muncie, IN 47302

(800) 435-9262

Fax: (765) 741-0057

or via the Internet at: http://www.modelaircraft.org

1. Assemble the plane according to the instructions. Do
not 
alter or modify the model. If you make any
modifications, you will void your warranty.

2. Test the operation of the model before each flight to
insure that all equipment is operating properly, and that
the model remains structurally sound.

3. Fly only on calm days (with wind speeds less than 5
mph) and in large open areas free of trees, people,
buildings or any other obstacles.

Remember: Take your time and follow the instructions
to end up with a well-built model that is straight,
durable and easy to fly.

The R/C model hobby becomes more and more
enjoyable as your experience grows. Your chances for
success and graduation to higher levels are very good if
you take your time and follow the assembly and flying
instructions carefully and completely. We hope you
enjoy flying your SKY ZAP plane.

Electronic Speed Control with Auto Cut-off: This unit
controls the motors. Also, it monitors the battery voltage
and turns off the motors when the voltage gets low. That
way there will be enough battery power to only operate
the motors for steering during the landing.

Motors: The motors rotate the props to provide thrust.

NiMH Battery: Rechargeable batteries which are used
as power for the airplane.

Transmitter (TX): This is the hand-held unit that sends
the signal to the receiver. As you move the sticks on the
transmitter, the motors in the airplane will react
accordingly. 

GLOSSARY

PRECAUTIONS

PROTECT YOUR MODEL, YOURSELF

AND OTHERS.

FOLLOW THIS IMPORTANT SAFETY

PRECAUTION

2

Содержание Sky Zap













Отзывы: