9
Assemble the Wing
For this section you will need:
1
-Left Wing
1
-Right Wing
1
-360mm [14-1/8"] Steel
Wing
Rod
1
-25mm [1"] Steel
Alignment
Pin
2
-4 x 25mm Screws
6
-4 x 8mm Screws
2
-Fixed Flaps
1
-Phillips Screwdriver
Please note that all images show the bottom of the wing.
❏
1. Install the 360mm [14-1/8"] wing rod and the 25mm [1"]
steel alignment pin into the right wing CenterCore wing rib.
The wire you see coming out of the servo is the servo lead.
This servo lead will not be used until the
“Center the Control
Surfaces”
section on page 12.
❏
2. Carefully slide the left wing all the way onto the rod and
into the CenterCore wing rib. The wing needs to be pushed in
all the way until it stops.
❏
3. Use two 4 x 25mm screws to hold the two wing halves
together.
❏
4. Remove the tape that holds the aileron pushrods
together and install the left aileron pushrod on the left aileron
horn. Slip the clevis retainer onto the clevis.
❏
5. Locate one of the SpeedBrake Training Flaps. There are
three small holes drilled into the TE of the wing near the center.
Install the fl ap to the wing using three 2 x 6mm screws. The
inner end of the fl ap should align with the end of the aileron.
