6
®
BATTERY CHARGING
BATTERY CHARGING
WARNING!!
The charger supplied with the Heli-Max 200FP
V-Cam Helicopter contains protective circuitry. If you experience
any difficulties while charging the battery, please disconnect the
battery from the charger and unplug the charger from the power
source. Allow the battery and charger to rest for two hours as this will allow the
charge protection circuit to reset. If this issue re-occurs during normal use, please
contact technical support for further assistance.
Charge the Flight Battery
1. Plug the wall power supply into any
110V standard outlet. Plug the 4mm plug
into the side of the charger box. The red
LED will light and the charger will sound
a beep letting you know your charger
is receiving power. Plug the battery’s
balance lead (the white connector) into
the side of the charger. The charger will
again beep and the green LED will start
to flash. Charging is complete when the
charger beeps and the red and green
lights remain on.
WARNING:
NEVER leave your charger unattended when charging and always
unplug the battery pack from the charger when charging is completed.
Transmitter Setup
1. Install 4 AA batteries in the transmitter
by removing the battery cover from the
back of the transmitter. Double-check
the polarity of each battery before
replacing the battery cover.
2.
Turn the transmitter on and lay it
down. Make sure that the blue light
behind the Heli-Max panel is lit. The
LCD screen should be on, with a
throttle position indicator and other
information.
