– 4 –
PL-41409-1
SWITCH KNOB
GAUGE PLATE
LATCH KNOB
TOP KNIFE COVER
CARRIAGE TRAY
RETAINING CLIP
MEAT GRIP
CARRIAGE TRAY HANDLES
INDEX KNOB
FENCE
OPERATION
SAFETY
SAFETY DEVICES INCORPORATED IN THIS SLICER MUST BE IN THEIR CORRECT OPERATING
POSITIONS ANYTIME THE SLICER IS IN USE.
The T
OP
K
NIFE
C
OVER
must be in position and secured with the L
ATCH
K
NOB
(Fig. 2). The R
ING
G
UARD
is
not removable. The D
EFLECTOR
, mounted below the slicer knife, can be removed for cleaning.
The M
EAT
G
RIP
(Fig. 2) must be used when slicing short ends to keep your hand(s) away from the knife.
When the slicer is not running, the I
NDEX
K
NOB
(Fig. 2) must be turned back below zero (fully clockwise).
The G
AUGE
P
LATE
will then cover the knife edge.
Always UNPLUG the P
OWER
C
ORD
before cleaning or moving the Slicer.
Model 2812
Fig. 2
WARNING
: ROTATING KNIFE. USE FEED GRIP. UNPLUG MACHINE POWER CORD BEFORE
CLEANING, SERVICING, OR REMOVING PARTS. REPLACE PARTS BEFORE USE.
SLICING — MODEL 2812
With the Gauge Plate fully closed, pull the Carriage all the way toward you until it reaches its stop. With
the Meat Grip out of the way, place the product to be sliced on the Carriage Tray. Set the Meat Grip
against the product.
If the Meat Grip is not needed, it may be stored out of the way by rotating it behind the top of the Carriage
Tray where it can rest on the Retaining Clip (Fig. 2).
Adjust the Gauge Plate to obtain the desired slice thickness by turning the Index Knob (Fig. 2). The
numbers on the Index Knob do not indicate actual measurements but may be used for reference to
duplicate slice thickness. Turn the slicer on by pulling the Switch Knob (Fig. 2) forward until it starts
and then releasing it. Slicer will not stay on unless the gauge plate is opened first. Unless the Gauge
Plate is opened before pulling the Switch Knob on, the slicer will not continue to run when the Switch
Knob is released.
Use either Carriage Tray Handle (Fig. 2) to push the Carriage back and forth to slice.
Turn the slicer off by pushing the Switch Knob or by closing the Gauge Plate.
