112
•
Lever the control cable end provided with
the silver bolt off the hub interface, e.g. with
a small screwdriver.
•
Loosen the axle nuts and external tab washers
on both sides of the hub.
•
Pull the rear wheel out of the frame by giving
it a gentle shake.
•
Remove the belt from the rear pulley without
twisting.
•
Insert a yellow transport lock between the
brake pads to prevent accidental adjustment
of the brake pad spacing.
6.6.3. Changing the tyre/tube
•
Unscrew the valve cap and large knurled nut from the valve.
•
Completely release the air by applying pressure to the valve pin in the centre of
the valve.
•
Use tyre levers to loosen the tyre on one side
of the rim. If necessary, use detergent and
water to lift the tyre off more easily.
•
Remove the tyre and tube and implement the
desired change.
•
Lightly inflate the tube (approx. diameter of 2 cm) and insert it into the tyre.
•
Insert the valve through the valve hole in the rim and pull the tyre and tube
combination from one side onto the rim.
•
Observe the running direction of the tyre imprinted by the manufacturer.
•
Then lever the other side of the tyre onto the rim using tyre levers.
•
Turn the knurled nut onto the valve until it reaches the rim.
•
Inflate the tyre to the maximum pressure indicated on the tyre wall so that the
tyre sits evenly on the rim. It is normal to hear a "plop" when doing so.
•
Then lower the pressure to the desired value (see section 3.1.).
•
Screw the valve cap onto the valve.
Maintenance
Содержание SD3 Urban
