HMS ZM 5005, Руководство пользователя, Страница: 10 / 32

10
PRODUCT
Przygotowanie
Remove all the packing and place them on a clear floor.
Based on the packing list, carefully check that all parts are complete.
Składanie
1. Hold the pull pin with your hand and pull it out, then rotate the pull pin to
lower the column. Put it in the designated posion and restore the pull pin.
(as shown in Figure B-C)
2. Install the slide rail group; use the 5mm, 6mm type hex wrench, the hexa-
gonal semi-circular head screw M8*20--4, and the curved washer 4, Hexa-
gon socket head cap screws M8*35--2 lock the rail set (as shown in Figure
D, but do not lock the screws)
3. Load the cushion set into the rail set. (as shown in Figure E)
4. Install the rear connecon and the stopper into the slide rail group; use the
5 mm, 6 mm type hex wrench, the hexagonal semi-circular head screw
M8*20--4, the curved washer 4, the hexagon socket head screw M8*35--2
will lock the rear connecon; finally lock all the screws. (as shown in Figure F)
5. Tight all bolts
screen
holder
seddle
screw
rail