8) Attach front handlebar
Attach the Front handlebar (69) to the Front upright tube (11) with two M8×20 Bolts (42)
and two Φ8 Arc washers (33).
9) Attach the Left & Right Pedals
Attach the Left & Right pedals (15/16) to the Crank axis (39). The Left Pedal (15) should be
threaded on counter-clockwise. The Right Pedal (16) should be threaded on clockwise.
(Refer figure10)
NOTE:
The Left & Right Pedals (15/16)
and Crank axis (39) are marked with “
L
” & “
R
”.
10) Adjust the
Seat tube
To adjust the seat forward and backward, loose out
the knob (20), move the Seat cushion adjustor (2) to
the proper position, then lock knob (20). (Refer figure
9)
COMPUTER
SPECIFICATIONS
：
KEY FUNCTION
：
MODE:
This key lets you to select and lock on to a particlar function you want.
According to the above three seconds longer, except ODO numerical
beyond, time and distance and the quantity of heat is cleared.
PAUSE:
Press to start or stop the operation of functions.*(IF HAVE)
SET:
The key allows you to choose a target value for TIME,DISTANCE,CALORIES
，
PULSE ,But SPEED and ODO cannot set
RESET:
RESET KEY to set the target KEY specific cleared, long press RESET for KEY
specific more than 3 seconds above, electronic watch RESET all numeration
RESET
OPERATION PROCEDURES
：
1.AUTO ON/OFF
◆The system turns on when any key is pressed or when it receives an input from the
speed sensor.
◆The processor turns off automatically when the speed sensor has no signal input or no key is pressed for approximately 4
minutes.
2.RESET
：
The unit can bo roset by changing the batteries or pressing the RESET key for3seconds.
3.HOW TO PRESET TIME,DISTANCE,ODOMETER PULSE&CALORIES:
Press the MODE key until the function brand which is going to be preset is flashing.
Press the MODE key once the function brand stop flashing.
Next, Choose the value you want to exercise by the SET key.
When the speed sensor has any signal input,The monitor will begin to count down.
lt will beep for 4 seconds to indicate the completion of workout which is preset,Press any key to stop beeping. lf data is not
preset,any function date will count up.
4.FUNCTIONS:
TIME
：
The time of exercise will be dispiayed by pressing MODE key until brand TIME appear.
SPEED
：
Current speed will be shown by pressing MODE key until brand SP(SPD) appear.
DISTANCE
：
The distance of each workout will be displayed by pressing MODE key until brand DIST appear.
ODOMETER
：
Press the MODE key until the pointer advance to ODO the total accumulated
*(IF HAVE)
distance will be shown.
PULSE
：
Users current heart rate is displayed in beats per minute(BPM)by pressing
*(IF HAVE)
MODE key until brand PULSE
appea,Place the palms of your hands on both of the contact beds and wait for30seconds for the most accurate reading.
CALORIES
：
The calories burned will be displayed by pressing MODE key until brand CAL appear.
SCAN
：
Auntomatic display of the followig functions in the order shown:
TIME-SPEED-DISTANCE- -CALORIES- ODOMETER (if have)- PULSE(if have) (OR) TIME-SPEED-DISTANCE-ODOMETER
(if have) - PULSE(if have) -CALORIES
BATTERY
This monitor uses two batteries. If improper display on monitor, replace the batteries to have a good result.
