Appendix B: UL Ordinary Locations (OrdLoc)
36 (38)
B
UL Ordinary Locations (OrdLoc)
SG-basic devices are certified for use in ordinary locations in compliance with the following
standards:
•
UL 61010-1 SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR MEASUREMENT,
CONTROL, AND LABORATORY USE - PART 1: GENERAL REQUIREMENTS - Edition 3 - Revision
Date 2016/04/29
•
UL 61010-2-201 STANDARD FOR SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR
MEASUREMENT, CONTROL, AND LABORATORY USE - PART 2-201: PARTICULAR
REQUIREMENTS FOR CONTROL EQUIPMENT - Edition 2 - Issue Date 2018/05/14
•
CSA C22.2 NO. 61010-1-12 SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR
MEASUREMENT, CONTROL, AND LABORATORY USE. PT. 1, GENERAL REQUIREMENTS -
Edition 3 - Revision Date 2016/04/29
•
CSA C22.2 NO. 61010-2-201:14 SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR
MEASUREMENT, CONTROL, AND LABORATORY USE - PART 2-201: PARTICULAR
REQUIREMENTS FOR CONTROL EQUIPMENT - Edition 2 - Issue Date 2018/02/01
The certification number of the certified devices according to OrdLoc certification is:
•
E214107
According to the standards listed above, the devices are certified with the following marking:
Intended Use
SG-gateways are used to connect MODBUS devices, energy communication systems and
industrial equipment with each other and to SCADA or cloud systems. They are intended for
installation on standard DIN rail.
Risk of interference if used with antenna (wireless)!
In case of interference install device or antenna in other location.
Use antenna exclusively in areas where operation of wireless equipment is allowed.
If antenna is installed outdoors, make sure to be in compliance of lightning protection
standard VDE V0185.
Modifications of antenna or connection such as extension cords may void the certification
for the cellular modem for certain regions.
Use in dry rooms exclusively. Protect product from moisture and humidity.
Protect product from too high or too low temperature, and from fire.
Damaged device caused by reverse polarity or wrong type of power supply!
Make sure that power is connected with correct polarity and that power supply is of
recommended type.
The equipment must be electrically grounded through the DIN rail for EMC compliance.
Make sure that the equipment is correctly mounted on the rail and that the rail is
properly grounded.
SG-basic User Manual
4.01.0401.20001 1.1 en-US