HMS BE4545, Руководство пользователя

Страница: 12 / 33

“ F19 ” to “ F24 ” means Highway
The operation method :
Press SOFT/HARD +,the CALORIES window will show
“ F01 ” - the softest base. Press “ + ” again,it change to “ F02 ” ,and so on,till “ F24 ”
the hardest ;same way,it can change from “ F24 ” to “ F01 ” ,customer could choose which one is most suitable.
Press START/STOP button to start or pause the workout
SPEED
‘ + ’ this sign to be increase the speed. ‘ - ’ this sign to be decrease the speed.
B.
DISTANCE MODE
In standby, press MODE, the DISTANCE window displays Pb. The system speed will change automatically in each interval according
to program settings. The speed can be changed by pressing the buttons
“ +/- “ +, but when the program enters the next segment, the
speed of the segment will be resumed. After finishing the workout device will make Bii sound and show END on the display. Device
will stop smoothly and turn into standby mode.
C. Mode sheet
4.Safety
In any circumstances, remove the safety switch, the system is down and sends alarm sound(all the windows show “ - ”).
Lubricating
The running belt must be lubricated with specially configured methyl silicone oil after used for a period of time.
1. Advice:
When use time a week is less than 3 hours, it should be lubricated once in five months.
When use time a week is between 4-7 hours, it should be lubricated once in two months.
When use time a week is more than 7 hours, it should be lubricated once in one month.
When use time a week is more than 7 hours, it should be lubricated once in one month.
It can’t be over -lubricated. It is not the more lubricant, the better. Remember: proper lubricating is the important factor to increase
the treadmill’s se rvice time.
2. Lubricating methods
For the methods to examine whether it is needed lubricant, you only need catch up the running belt and touch the central part of
the back of the belt with hand as nearly as possibly. If the belt is with silicon resin (a bit sense of dampness) inside, this means no
lubricant is needed; if the running board is dry and you feel no silicon resin inside, this means lubricant is needed.
A. Steps for coating the running board with lubricant: (see the picture)
B. Stop the machine, remove safety key.
C. Pick up the belt, coat the inner side of the belt with silicone oil and coat both sides of the belt with silicone resin. Place safety
key in right position, press star and set speed into 1km/h put your hand on the middle part of the board and keep in the position for
several seconds then move from left to the right to spread the grease under the belt