HMS ATLAS TYTAN 7, Инструкция по эксплуатации

Страница: 23 / 53

STEP 2
1. Slide the Higher Bushing (21) and the
Lower Cover Support (97) onto the Guide
Rods (13).
2. Slide two Weight Buffers (39) onto the
Guide Rods (13). Then install each
Weight Plate (33) onto the Guide Rod
(13).
Note: Carefully slide the Weight Plates
(#33) one by one onto the guide rods,
do not lift more then you can control
safely.
3. Slide the Weight Bushing (35) onto the
Weight Selector Bar (37) and align pin hole.
Secure the Weight Bushing (35) onto the
Weight Selector Bar (37) by inserting the
Weight Pin (36) through into the first hole of
the Weight Selector Bar (37) and Weight
Bushing (35). Slide the Top Weight Plate (32) onto the Weight Selector Bar (37) and Weight Bushing (35). Place the Weight
Washer (34) onto the hole of the Top Weight Plate (32).
4. Finally, install the Top Weight Plate (32) with Weight Selector Bar (37) onto the Guide Rod (13). Insert the L-Pin (38) into the
pin slot.
STEP 3
1. Separately insert three PT80x40 Plugs (52)
and the 38x38 Plug (50) into the ends of the
Top Beam (4).
2. Attach the Top Beam (4) to the Main Upright
(3) with two M10 Nylon Lock Nuts (68), two
M10x60 Hex Bolts
(75), and four φ10
Washers (64).
3. Attach the Upper Cover Support (96) and
the Top Beam (4) to the Guide Rod (13) with
two M10x25 Hex Bolts (73) and two φ10
Washers (64).
4. Insert the 38x38 Plug (50) into the Resist
Bar (12). Install the End Cap 38x38 (54) onto
the Resist Bar (12).
5. Attach the Resist Bar (12) to the Main
Upright (3) with one M10 Nylon Lock Nut (68)
and one φ10 Washer (64).