7
9.
Press the right arrow button to move the cursor to the power select list. Use the up and down arrow buttons to
select the desired transmit power for TX1. Choose the lowest power level that gives sufficient range. If you
are unsure, choose 100 mW to start. You can increase or decrease it later. When you have selected a power
level, press ENTER. The selected power level will now be highlighted at the top of the power window.
10.
Press the right arrow button to move the cursor to the mode selection. If the radio button (small circle) next
to
Off
is black, press the down arrow to move the cursor down to the radio button next to
On
. Then press
ENTER. The black circle will move down and the transmitter will come on.
11.
Press the right arrow button again. The cursor will return to the transmitter selection window. Press the
down arrow button to select
Tx2
. Then press ENTER.
12.
Repeat steps 9 and 10 for the second transmitter (
Tx2)
. Then press CANCEL to close the
Base TX Power
window. If you only require one channel operation, you can leave Tx2 off.
13.
Next, you must enable the receivers. Press Receiver Quick Menu button 1 (#4 on the illustration). This will
cause the
Base RX Setting
window to appear.
14.
Press the left arrow button once to move the cursor to the mode radio buttons. If the
On
radio button is
black, skip to the next step. If the
Off
radio button is black, press the down arrow button to move the cursor
down to
On
and press ENTER. The
On
radio button will turn black and receiver 1 will be enabled.
15.
Press the next Receiver Quick Menu button (2) and repeat step 14 to enable receiver 2. Then do the same
for receivers 3 and 4.
16.
Press CANCEL to close the
Base RX Setting
window and return to the
Config
menu.
17.
The next step is to save these settings. Use the down arrow button to highlight
Files
. Then press ENTER to
open the
System Setup
menu.
NOTE:
Settings must be saved before the power is shut down or they will be lost. This is true any time you
change base settings. Be sure to save them.
18.
Be sure that
Save Settings
is highlighted (use the up arrow button if necessary) and press ENTER. The
Save Settings to File
window will appear. File 2 should be highlighted as shown.
19.
Press the right arrow button to move the cursor (small triangle) to the check box next to the word
Save
.
Then press ENTER. It will take a few seconds to save the settings. When the settings are saved,
Success
will be displayed in the window.
20.
Press the CANCEL button to close the
Base RX Setup
window. Press the CANCEL button a second time
to return to the
Config
menu.
The base is now configured and ready to use. Next you must upload these configuration settings to each Beltpac.
