6
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
Any changes or modifications not expressly approved by HM Electronics, Inc. could void the user’s authority to operate
the equipment. To comply with FCC radiation exposure requirements, use of this device is limited to configurations tested
and approved by HM Electronics. Other accessories used with this device must not contain any metallic components.
This device is a radio transmitter and receiver. When it is on, it receives and sends out RF energy. In August 1996, the
U.S. Federal Communications Commission (FCC) adopted RF exposure guidelines with safety levels for hand-held
wireless devices. These guidelines are consistent with the safety standards previously set by both U.S. and international
standards bodies in the following reports:
•
••
•
ANSI C95.1 (American National Standards Institute, 1999)
•
••
•
NCRP Report 86 (National Council on Radiation Protection and Measurements, 1986)
•
••
•
ICNIRP (International Commission on Non-Ionizing Radiation Protection, 1996)
This device complies with the standards set by these reports and the FCC guidelines.
Hereby, HM Electronics, Inc. declares that the COM6000 is in compliance with the essential requirements and other relevant
provisions of R&TTE Directive 1999/5/EC.
This product operates in the 2400 to 2483.5 MHz frequency range. The use of this frequency range is not yet harmonized
between all countries. Some countries may restrict the use of a portion of this band or impose other restrictions relating to
power level or use. You should contact your Spectrum authority to determine possible restrictions.
The term “IC:” before the certification/registration number only signifies that the Industry Canada technical specifications
were met.
IC Notice to Users English/French in accordance with RSS GEN Issue 3
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence (s). Son utilization est soumise à Les
deux conditions suivantes: (1) cet appareil ne peut pas provoquer d'interférences et (2) cet appareil doit accepter Toute
interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif.
This device complies with Health Canada’s Safety Code 6 / IC RSS-210. The installer of this device should ensure
that RF radiation is not emitted in excess of the Health Canada’s requirement. Information can be obtained at:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guidelignes_direct-eng.php
Cet appareil est conforme avec Santé Canada Code de sécurité 6 / IC RSS-210. Le programme d'installation de cet
appareil doit s'assurer que les rayonnements RF n'est pas émis au-delà de l'exigence de Santé Canada.
Les informations peuvent être obtenues:
http://www.hc-sc.gc.ca/ewhsemt/pubs/radiation/radio_guide-lignes_direct-eng.php
