HLS INFRABEAM IB2017-1, Инструкция по эксплуатации и сборке

Страница: 34 / 36

HLS Infrabeam EN 34
To adjust power of heating tubes:
The left control knob controls the total power
of two left tubes, and the right knob controls
the total power of two right tubes. Increase the
power by turning the relative knobs clockwise,
reduce the power by turning the relative knob
counter-clockwise. Each side has 7 power set-
tings but both sides totally have 8 settings.
Accordingly, the power setting bars show the
setting of the power. The more bars show, the
higher power the relative tubes are.
In addition, This grill has a power limit function,
the total power of all heating tubes do not ex-
ceed the Max rated power, and accordingly, the
total number of the power setting bars would
not exceed 8, which could be 4 bars each side
or 1 bar one side and 7 bars on the opposite side
etc. When we turn knob at one side to increase
the power of tubes at the same side, the built
in program will decrease the power of tubes on
opposite side if the total power exceeds the Max
rated power.
OVER TIME AND OVER HEAT
PROTECTIONS
Over time: When the grill has worked with po-
wer for more than 90mins and there is not any
manual operation, the grill automatically turns
off all heater tubes and goes to „stand by“ mode,
the over time warning words flash on the digital
displayer.
Over heat: When the grill body is extremely hot
which might cause potential damage, The grill
automatically turns off all heater tubes and goes
to „stand by“ mode, the over heat warning words
flash on the digital displayer.
Warnings: If over heat happens, the grill does
not respond to any manual operation before it is
unplugged and plugged again, if it happens re-
peatedly, don not use the grill again, but fix the
problem by qualified persons.
CLEANING YOUR GRILL
ALWAYS UNPLUG THE GRILL BEFORE
CLEANING MAKE SURE THE GRILL IS
COOL BEFORE CLEANING.
• NOTE:
Never immerse the grill body in any
liquid.
NORMAL CLEANING
• Take out the wire grid, warning rack,
reflector and oil pan from the grill, wash
them with soapy water using a dishcloth or
dish brush.
• Do not clean with steel wool pads or
abrasive materials. If scrubbing is necessary,
use a nylon or polyester mesh pad.
• Wipe the heating tube protection guard and
its base by using damp dishcloth or sponge
with a mild dish washing detergent. use a
soft cloth moisten with mild soap, and then
use a dry cloth to wipe it again.
• NOTE: To maintain best heating power it
is recommended to follow above cleaning
instructions after every time you use the
grill.
WARNING: Do not squeeze out any Liquid from
the Sponge or Dishcloth whilst cleaning.