(4)Cut the center of each of the 6mm hoses and
and insert a 6x6x6 T‑Fitting in each.
Advice
・Use 6mm hose clamps to secure hoses.
(2)Connect the actuators of each of the two
turbochargers using 6mm hose.
(3)Connect each compressor of the two
turbochargers using 6mm hose.
Advice
・Use the 6mm hose and 6mm hose clamps.
−20−
2.5.Twin Turbo Applications (Swing Valve Type)
6mm Nipple
6mm Hose
NippleO
Actuators
Actuators
Remove These
IN
IN
EX
IN
IN
EX
6mm Hose
6x6x6 mm
T‑Fitting
Actuator
IN
IN
EX
6mm Hose
6mm Hose
(6)Install the 6mm nipple to the wastegate's
upper port.
(7)Using 6mm Hose, connect the EVC Stepping
Motor's NippleO to the 6mm nipple installed
on the wastegate in step #(6).
To install this unit on to a twin turbo vehicle, the hose set for the twin turbo
vehicle is needed. The basic hose layout procedure is similar as the swing valve.
(1)Remove the factory hoses between each
turbocharger's compressor and actuators.
www.R33-GTR.org
Содержание 45003-AK005
