Hkoenig STM45, Инструкция по эксплуатации

Страница: 12 / 71

Fault Recovery
Fault Recovery
Fault Cause Solution
The machine does not
work or the indicator light
of switch is not lighted Power-off or fusion of fuse Check and confirm
The socket is not connected or
plugged in properly Connect to the power supply and ensure the plug is
plugged in thoroughly
Unfavorable connection of socket Check whether the power socket is normal or not
The power switch is not turned on Turn on the power switch
The indicator light is on
but there is no steam The water in water tank does not
reach the designed water level Fill water promptly
The water tank is not installed in
position Install the water tank in position
Severe inflection of steam conduit Straighten the steam conduit
Water don’t flow into boiler Shaking water tank or re-placed the water tank
The accessories of ironing
brush are not fastened Unaligned grip Realign and fasten the snap close
Less, discontinuous or no
steam The water in water tank does not
reach the designed water level Fill water promptly
The water tank is not installed in
position Install the water tank in position
Severe inflection of steam conduit Straighten the steam conduit
Less volume of steam Blockage of filter sieve Wash the clearing plug at bottom
Blockage of water tank Wash the filter sieve of water tank
Water don’t flow into
boiler Blockage of water intake Wash the water intake
The water tank is not installed in
position Install the water tank in position
Water tank deformation Used hot water Replace the water tank
Overflow of water tank Cracking of water tank Replace the water tank
Breakage of seal ring Replace relevant fittings
If the problems above are still not solved, inform the professionals and do not dismantle the
machine without authorization.