12
4 Place back the filtering sponge at the left end (the further
position from the cleaning roller motor) of the water sink.
2 To move the appliance, use the hand lifting position at the
appliance’ s back, or lean the appliance backward a little and
move by the auxiliary wheels.
1 Switch off the appliance, lock it in an upright position.
2 Open the cleaning head cover, press the square button at
the lateral side to take out the brush roller (Maximum open angle
of the drive motor is 30°. Please use appropriate strength and
method to avoid any damage).
3 Insert a new brush roller onto the motor, push and fix it into
the cleaning head till the lateral button is in place.
If you want to continue to benefit from the best cleaning results,
make sure you always use the original HIZERO brush roller, and
we recommend you to replace it every six months.
5 Place the water sink back correctly, making sure the
positioning holes on the water sink match rightly with the
machine body, then slightly press the water sink from left to right
to check if it is fixed well, and lastly make both ends of the water
sink flush.
6 Finish the rest installation steps.
5.8 Cleaning/Replacing the Filtering Sponge
1 Take out the water sink (refer to the Section 5.7).
1 Before storing, switch off the appliance, lock the body and
place it onto the charging base.
1 Make sure the appliance is switched off and locked in upright
position.
2 Please clean the inside of the cleaning head before storing
to avoid bacteria breeding.
3 Before storing, please make sure the water tanks are empty.
4 If the appliance will be out of service for above one week,
please cut the power off, remove the cleaning roller and store it
after drying.
2 Clean/Replace the filtering sponge.
3 Put back the water sink (refer to the Section 5.7).
4 Finish the rest installation steps.
Note: The filtering sponge should be placed at the left end of the
water sink to improve the cleaning efficiency, and it is suggested
to replace the filtering sponge every 2 weeks.
Note: If there is sand or sharp objects on the floor, do not
operate the appliance to avoid any possible scratch.
Note: Do not let the appliance standby on wooden floors for a
long time to avoid any possible damage to the floors.
Note: The maximum open angle of the drive motor is 30°. Please
operate it carefully.
6 Storing & Moving
7 Replacing
6.1 Storing
7.1 Replacing the Brush Roller
6.2 Moving
1
2
3
30º
4
5
6
7
