HD-SDI DVR HF-406 / 812 / 1612
63
- System Event source
System Event source can configure Bad block, Disk full,
Fan error, authorization failure, WRS registration failure,
Mirroring Disk Full, Power on, & Abnormal recording
stops.
- Relay 1~4
Event notification will be achieved throughout relay 1~4 as much as user set duration time.
- Buzzer
Event status will be reported by buzzer based on time duration set by user.
- E-Mail Set up
Input E-mail address to receive event alarm by E-Mail
•
E-Mail Address :
Input E-mail address with receiver’s
E-mail information.
E-mail format should be
and the
users must only use combination of numbers and the
English alphabet.
• Sender’s E-mail address
: Sender’s E-mail address is set when user use E-mail for output selection and
user setup E-mail address as
. User doesn’t need to input fixed address for E-mail but
address which can be distinguishable.
• Authentication
: There are 3 ways to send E-mail, Non-authentication sending, SMTP server authentication,
TLS authentication. Non-authentication is to send e-mail without authentication from authentication server.
SMTP server authentication is to send e-mail after an authentication of sender’s e-mail address from SMTP
server. TLS authentication is to send e-mail after an authentication of sender’s e-mail address from TLS
server
• Including Picture
: In general event, when sensor, MD, V-loss events are generated, an event information
with triggered channel video recording will be sent via email to an user defined email address.
